How to adjust the ice machine?

       In the hot summer, the frequency of use of the ice machine has also risen, it is inevitable that there will be some failures, to understand the relevant equipment and learn simple troubleshooting,
today's Esmer ice machine Xiaobian will tell you about the common faults and solutions of the ice machine: Vol.1 Not make ice

1、 Not placed horizontally - required to be placed horizontally
2、 Ice board probe faulty or too close - Replace or adjust ice board probe
3、 Whether the solenoid valve leaks -- Replace the solenoid valve and filter
4、 Refrigerant leakage - Check the leak, repair welding, vacuum and add refrigerant

Vol.2 Noisy

1、 The fan is noisy - check the fan blades, install screws, and correct or tighten them
2、 Chassis deformation - adjustment
3、 The compressor itself is noisy - adjust and replace
4、 Cooling system pipeline matcha - adjust the pipeline route

Vol.3 No water, no water

Be divided into two conditions:
1、 The pump works but does not fill the water

There are several possibilities

1、 There is air in the pipe - air is discharged from the pump
2、 Too much ice residue at the bottom - stop the drainage restart
3、 Pump impeller wear - replace the pump
2、 Pump not working

There are two possibilities:

1、 The pump is broken - replace the pump
2、 Poor wiring or circuit board failure - Check the circuit or replace the circuit board

Vol.4 The ice tray has ice on the top and no ice or thin ice on the bottom

1、 Ice tray mounting too tilted - adjust mounting
2、 Less snow seed - After determining the snow seed, add the snow seed appropriately
3、 Not placed horizontally - placed horizontally

Vol.5 Compressor failure

1、 Low voltage - Adjust the voltage
2、 Check start protector - replace if damaged
3、 Whether the compressor is normal -- If not, replace the compressor.